Recent content by droogiee

now i am getting 450 down and 380 up over and over on a wired and wireless device.. what to check now

i get 1 GIG link.. i can run tests on both local networks and i get 960 mbps speeds.. it is not a link somehwere... when i run speedtest.net i get 500mbps up down and work and at home

[ ID] Interval Transfer Bitrate [ 5] 0.00-1.01 sec 3.12 MBytes 26.0 Mbits/sec [ 7] 0.00-1.01 sec 1.88 MBytes 15.6 Mbits/sec [ 9] 0.00-1.01 sec 2.00 MBytes 16.6 Mbits/sec [ 11] 0.00-1.01 sec 3.50 MBytes 29.1 Mbits/sec [ 13] 0.00-1.01 sec 896 KBytes...

one way was 90 mbps running it the other way i got 220 mbps, i ran the tests 3 times each.. every time was the same

can i run openspeed test instead?

any thing above ping REMOTE_PC_IP -f -l 1360 failed these are ethernet only. cpu is bouncing from 75-90 on my end, 45% on the other speeds are bouncing alot 5 mb/s to 20 mb/s average is 9 mb/s now haven't done the iperf3 test.. is that with powershell?

finally got the site to site working between the two synology routers... but speeds are still slow. i have contacted tech support, and they will be looking into this.. but in the meantime i am curious as to what could be causing this. tried from multiple different PCs on either end, to different...

how is port 25 and 587 different then? if they both have STARTTLS

i thought port 25 and 587 does not use encryptions

their response is: Your printer is working correctly, the issue is that it uses an older TLS security method that our upgraded mail servers no longer support. The printer cannot complete the required STARTTLS handshake, so the server rejects the connection. Gmail and Zoho still support the older...

i have all important pcs static. i am unable to access the computer with the static ip address..

also, unable to access windows shares via site-to-site via windows SMB shares.. i can via hamachi, or SSTP,

ok, got site to site up and running, but is not translating names, only IP addresses.. i see not settings anywhere

they are both synology routers

i have a syhnology RT6600ax, that does have site to site, but no preset templates.. only manual.. can i use wireguard with the my router? with hamachi i have a direct, non-relayed connection.. but still bad huh?