Recent content by PeaceKeeper

Hello there, So far after playing a couple of graphics intensive games, I have not encountered any BSOD when exiting games. Hooray! Thank you Cybercore for your help. I guess the setting of the correct RAM frequency and installing the latest ATI drivers did the trick

After a couple of times in the past few days of removing the ATI drivers, after restarting the pc, my screen hangs in the Windows loading part. Luckily, I managed to uninstall my current ATI drivers, cleaned it using the Driver Sweeper, and restart windows successfully last wednesday. Then I...

I could not uninstall the DVD Drive since the drive itself is not showing in the Device Manager. Also, the drive is working fine before, it just happened one day (I could not remember when >.<) it stopped working in windows. But as I said, in BIOS it can still be detected as I can still change...

Hello there, I have yet played any games after my last post, ill post after a day or two if anything comes up. Though there were some BSOD encountered while not playing games, e.g restarting windows or windows loading attached is a new set of dump files. kindly advice if the raw dump files...

Hello there, My motherboard is an MSI X58 Pro, I think it can support DDR1333 Btw, as you already noticed, I am not familiar with RAM frequency setting, I apologize for the irritation I might have caused you. Attached are the pictures I took of the BIOS, so you will have a visual...

btw, I do not know how to close a thread, any kind moderator can help me, thanks

Hello, the image mem_1333 is also from my pc where I manually set to 9-9-9-24 and increased the Memory ratio. So I guess I will have to use that one

Here are the new settings. Btw, after rebooting and loading the default setting, I then manually set the timing again to 9-9-9-24 and tried increasing the Memory Ratio in the bios until the Adjusted DRAM Frequency is 1333 from 1066. I then found out that the DRAM frequency in CPU-Z must be...

Hello there, Initially I bought 2 sticks on 2009, then I bought a 3rd stick in 2010. Also, from the start, the RAM setting is set to 'auto'. I then manually set it to 9-9-9-24. I'll try the load setup/optimized defaults.

Sorry about that, I was going through each step when I reported the uninstalling of ATI Attached are the memory and RAMmon exported as text file (weird I can't upload the html file) Btw, I tried this "Control Panel > Device Manager > disable ATI card", there are two devices in the Display...

From AlphaA's link, I tried uninstalling the MagicISO but the virtual drives kept on going back after each reboot. Installing / Uninstalling doesnt do anything also. I also tried uninstalling VLC but still no avail on the DVD Drive.

Hello there, Current setting is 9-9-9-24. From the link you gave me, most atikmag.sys problems encountered downgraded their ATI Catalyst back to 10.11 or earlier. After restarts from uninstalling the latest ATI Catalyst and using Driver Sweeper to clean left files, screen does not...

Hello, Can't find any good reference about the RAM setting. Btw, my RAMs are 3x 2GB Kingston KVR DDR3 1333Mhz. Currently set up with RAM timing of 9-9-9-24 from Link Removed due to 404 Error. Haven't updated any drivers yet

My DVD Drive is a Samsung Superwritemaster and checking the Samsung website, their last firmware upgrade of this kind of dvd was on 2008, does not even support Windows 7

I have tried the link and unfortunately, it only sees the virtual drives to fix. I'll uninstall MagicISO (virtual drives) later then try the fix again. I already tried the registry fix but nothing happened.