Resolved! Hi Randy, Thank you! You were right. The solution WAS to assign static values to the IP addressing scheme. Previously, I had done it solely to the IP address, and Subnet mask, but no luck. However, when I also assigned the default gateway and DNS server addresses to the router...
Hi again Randy, Thanks for writing back. I inserted the values you instructed. Sadly, no joy. Afterwards, however, I went through the wireless card to get on the net, then re-enabled the Ethernet and captured the latest Ipconfig /all. It was identical to the previous one posted, except there...
Hi Randy, Thank you again for all the wonderful suggestions. As per your instructions, I did the following: 1) ipconfig /release and then ipconfig /renew 2) ipconfig /flushdns 3) assigning static values to the ip addressing scheme for the wired card In all the above cases, the same...
Hi Randy, Thank you so much for the great reply. I have already: 1) Rolled back the drivers (no joy) 2) Gone through Network Troubleshooter (when the wireless card hasn't been enabled/disabled, etc. to get to the net, the Wizard just looks and provides nothing; but when the wireless card HAS...
Hi, My hardwired Ethernet card will not connect to the internet when using my wireless router. Currently, to resolve this: 1) the Ethernet Card must be disabled; 2) the Wireless card must then be enabled; then, 3) once the Wireless card has found the internet, it (the Wireless card) must be...