A gaming PC enhances a 30 fps console stream with sharper visuals and interpolated frames on a sunset city-driving game.
A GTA VI "60fps on PC" story is circulating, and it is not what the headline suggests. GTA VI is not running natively on a PC. A PlayStation 5 is running the game, and a Windows PC is post-processing the video stream. Here is what is reported, what is verified, and what it means for anyone with an RTX card and a PS5.

A gaming PC enhances a 30 fps console stream with sharper visuals and interpolated frames on a sunset city-driving game. The short version​

X user phosphenq demonstrated the Veyra-NRVideo tool on GTA VI using a system with an Nvidia GeForce RTX 5080. The PS5's Remote Play feature supplied the video feed, so no extra capture hardware was needed. The result is a visually enhanced picture that looks smoother, running at 60fps instead of 30fps.

The console still renders the game at about 30fps. VideoCardz makes the same point: GTA VI continues to run at approximately 30 FPS on the PlayStation 5. The PC only changes what you see on screen.

What Veyra-NRVideo is​

Veyra-NRVideo is a community-built Windows video tool. Its project page describes it as a real-time GPU video enhancement tool that turns local video, capture cards and game streaming into one enhancement pipeline. The project's documentation lists several processing stages:

  • Super resolution and upscaling.
  • Denoising and HDR.
  • Frame generation.
  • Capture from PS5, Xbox, PC or screen sources.

The tool does not need a capture card for the PS5 route. You enable Remote Play and discover or enter the console's IP. You then use PSNTools to get your Account ID and enter the console's eight-digit pairing code. Phosphenq's walkthrough covers the same ground. It adds that the PS5 stream should be set to 1080p, 60fps and H.265. It also says DLSS 5 needs an RTX 50-series GPU, while frame generation works on RTX 40 and 50.

The project documentation says the tool targets Windows. The project's README lists Windows 11 x64 and DirectX 12 as requirements. It ships separate NVIDIA and AMD packages, and installing the wrong one causes problems.

The numbers, and who stands behind them​

Club386 attributes the performance figures to phosphenq. The DLSS 5 pass costs 4.1ms, according to phosphenq, with frame generation adding another 1.5ms. Club386 then adds its own estimates. It says the complete enhancement pipeline adds 12ms on top of the 33ms inherent to 30fps rendering. It also says Remote Play streaming can add another 10-20ms. Its total is about 70ms or more, which it compares to cloud game streaming.

Treat these as one tester's figures and one outlet's estimate, not independent benchmarks. Two things are worth noting:

  • The 4.1ms and 1.5ms components do not add up to the 12ms pipeline total. Other processing stages presumably account for the gap, but the source does not itemise them.
  • Phosphenq's own thread says the PC output was 4,700 frames against 2,351 console frames over 80 seconds. It says controls still react at 30fps and only the picture gets smoother.

The project's community wiki offers a different latency reference. It says nothing specific about GTA VI there, but its feature guide quotes the author giving 30-40ms for a DLSS 5 plus 4x frame generation setup. That is a different configuration and not this demo. The numbers will vary with hardware, capture path, network and display.

The wiki also describes frame generation as the icing on the cake, not a rescue. A 30fps source already carries 33ms of render latency, and frame generation cannot change that baseline. That matches the "smoother, not more responsive" framing.

Why this is not official DLSS 5​

Nvidia's research page describes DLSS 5 as a stage that runs locally inside existing game pipelines on GeForce RTX 50 Series GPUs. It says the model is conditioned on the current rendered frame, engine motion vectors, carried temporal state and artistic-direction values. A compressed video stream from a console carries none of that engine data.

Veyra's project page is open about the gap. It says community runtimes are not vendor certification or a complete official DLSS 5 integration. VideoCardz reports the same caveat. Expect different results from a game that ships with DLSS 5 built in. Club386 adds that Remote Play is capped at 1080p, which limits the detail the enhancement can work with and may cause artifacts.

Practical notes for would-be tinkerers​

  • Hardware: DLSS 5 features need an RTX 50 GPU. Frame generation works on RTX 40 and 50, per phosphenq. The Veyra wiki warns that high resolution and layered neural rendering raise GPU and VRAM demands. It also says a 30fps source gives weaker frame generation than a 60fps one.
  • Duplicate frames: the wiki says a PS5 streaming a 30fps game can deliver 60fps with half the frames duplicated. It recommends a "60→30" content cadence setting, and warns that doubling duplicates is a common cause of poor results.
  • Network: Club386 advises a wired connection rather than Wi-Fi to avoid dropped frames. That is sensible for any streaming setup, though it will not remove latency.
  • Start simple: the project page advises starting with effects off, checking picture and sound, and enabling effects one at a time.
  • Troubleshooting: the wiki asks for your Veyra version, GPU and driver, capture hardware, input format and logs when reporting a problem. It also warns against disabling Windows Security wholesale to get around an alert. Verify the download instead.

Caution on provenance​

Several things argue for scepticism.

  • The project is hosted in many GitHub forks with near-identical descriptions, and its tagline claims 120fps for PS5 GTA6. An analysis from explainx.ai noted that the README does not back up that GTA6 tagline.
  • Phosphenq's thread is also promotional. It points readers to a personal setup repository and to unrelated paid-content articles. Its setup route has an AI coding agent install software from that repository. Anyone doing this should review scripts before running them.
  • VideoCardz notes that the published benchmark data includes processed footage from existing PS5 gameplay captures.

None of this proves the demo is fake. It does mean the claims are a long way from a lab-tested result.

Bottom line​

This is a clever Windows video-processing trick, not a GTA VI PC port. The PC adds smoother-looking motion and a DLSS 5-style look to a console stream, at the cost of added latency and a 1080p ceiling on the PS5 route. If you value fluid motion over tight controls, it may be worth trying on an RTX 40 or 50 PC. If you want a responsive game, you are still waiting on Rockstar.


Update: Additional details (November 19, 2026)​

ThePCEnthusiast reports that GPU utilization reached approximately 39% during Phosphen’s RTX 5080 demonstration. The outlet says it did not personally test the configuration; the figure comes from publicly available demonstrations.

 

References

  1. You Can Play GTA 6 on PC Today, and Even Add Frame Generation, But There’s a Catch - ThePCEnthusiast ThePCEnthusiast 2026-11-19T12:13:58+00:00
  2. Modders are already playing GTA VI at 60fps on PC, complete with Nvidia DLSS 5 - Club386 Club386 2026-11-19T14:12:10+00:00
  3. GitHub - RegionPulley/Veyra-NRVideo: Bring PS5 GTA6 to 120FPS with DLSS 5. An advanced Windows video player and capture enhancement tool featuring real-time preview for videos, images, and capture card sources. Combine AI-powered Super Resolution, DLSS5 image enhancement, and Frame Generation to deliver a next-generation visual experience. · GitHub github.com