A 15.36TB enterprise NVMe SSD sits in a server rack, with cooling fans and glowing data pathways.
Phison's Pascari X201P 15.36TB is a PCIe 5.0 enterprise SSD with excellent write numbers at high queue depth. It is weaker on small, latency-sensitive writes and ran warm on the test bench. That is the verdict from Tom's Hardware, which reviewed the drive. The drive arrived under NDA alongside this week's Supercomputing 2026 event. For admins buying storage for AI, analytics and ingest servers, the main question is whether your workload looks like the benchmark.

A 15.36TB enterprise NVMe SSD sits in a server rack, with cooling fans and glowing data pathways. What the drive is​

The X201P sits in Phison's Performance X-Series. It is the read-intensive, 1 drive-write-per-day (DWPD) model and succeeds the X200P. Its mixed-use sibling, the X201E, is rated for 3 DWPD.

Tom's Hardware says U.2 capacities run from 1.92TB to 30.72TB. An E3.S version starts at 3.84TB, and both single-port and dual-port models exist. Phison's own materials describe the X201 family as available in U.2 and E3.S, with capacities up to 30.72 TB. Don't assume every capacity exists in every form factor and port configuration. Check the exact part number before ordering.

The review sample was a single-port, 15mm U.2 drive, part number XP208H0815T3P3216T310. It ran firmware X2WM6026 on a PCIe 5.0 x4 U.2 adapter card. The reviewer noted that earlier data reportedly came from X2WM6025, but confirmed X2WM6026 for every result used.

Per the review's spec table, no capacity had pricing listed. Some resellers do list individual part numbers. I haven't verified that any of those listings are current or in stock, so treat them as unconfirmed.

What the review found​

  • Spec compliance: The drive met or beat every rated figure the reviewer could test.
  • Writes: The headline numbers are a steady 12 GB/s sequential and over 600,000 random-write IOPS. That is notable for a 1 DWPD drive.
  • High queue depth: The 15.36TB model passed one million IOPS at QD128 in the 4K 70/30 mix. That is the scenario the review says the drive is aimed at.
  • Latency and AI checkpoints: The review's pros list includes tight write latency under load and quick AI checkpoint saves.
  • Weak spots: QD1 writes, log commits and the middle of the mixed-workload sweeps lagged. The sample also ran warm.

The random-read caveat​

Tom's Hardware's table lists a 3.25 million IOPS random-read rating for this capacity. The reviewer's standard interrupt-driven I/O could not reach it. The site also runs a polled-I/O test on every drive for cases like this. That test hit 3.283 million IOPS at the queue depth Phison specifies, so the drive does exceed its rating.

Interrupt-driven and polled results are not directly comparable. Compare like with like when you look at other drives.

Spec figures differ between sources​

The review table lists 14,800 MB/s sequential read, 11,800 MB/s sequential write and 3.25 million random-read IOPS for the 15.36TB model. Phison's published figures for the family are different. The Open Compute Project listing gives up to 14.8 GB/s read, 11.8 GB/s write and 3.3 million IOPS for the X201 family. A Phison brochure snippet lists up to 14,500 MB/s sequential read, 12,000 MB/s sequential write and 3,300K random-read IOPS. Those are family-level maximums, not per-capacity ratings.

Phison's random-write numbers also differ from the review table. Phison's CES 2026 blog cites 1,050K IOPS with the X201P as a peak figure. The review table rates the 15.36TB model at 600K. These are likely different capacity ratings or test conditions, but the sources don't say so. Read the datasheet for your specific capacity.

Capacity matters too. Per the review table, sequential write ratings climb from 2,300 MB/s at 1.92TB to 11,800 MB/s at 15.36TB. They then dip to 10,000 MB/s at 30.72TB. Random-write ratings follow the same pattern, from 75K up to 600K and then 490K. The review tested only the 15.36TB drive, so don't assume the other capacities perform alike.

Hardware details​

Phison didn't give firm hardware details, so these points are the reviewer's inferences or reports.

  • The reviewer says the 321-layer flash can only be SK hynix V9 TLC. It is a three-deck design the site hasn't tested before.
  • The reviewer says the X2 controller reportedly pairs Arm Cortex-R5 main cores with AndesCore RISC-V co-processors.
  • The review says the X2 is a 12nm part with 16 flash channels. It contrasts this with Marvell's Bravera SC5 and Silicon Motion's SM8366, which it says use Arm cores throughout.

Phison's CES blog offers a consistent explanation for the generational jump. It says the main difference is the use of faster TLC NAND on the X201 that greatly improves write performance.

Management and deployment features​

FeatureDetail
ProtocolNVMe 2.0d; OCP Datacenter NVMe SSD v2.0 with v2.6 telemetry features
SecurityISE, SED (TCG Opal 2.02) or non-SED; AES-XTS 256-bit; cryptographic and block erase
Data protectionPower-loss protection and end-to-end data protection
LBA formats512-byte and 4,096-byte, each with optional metadata
NamespacesUp to 128
Power statesSix: 25 W, 22 W, 20 W, 18 W, 15 W, 12 W
Temperature thresholds77°C warning, 85°C critical; host-controlled thermal management
FirmwareSeven slots, activation without reset
Out-of-band managementNVMe-MI 1.2 over SMBus and PCIe
Flexible Data PlacementNot supported

The 77°C and 85°C figures are product limits. The review doesn't say the drive reached either one or throttled. "Ran warm" is a bench observation, not a documented thermal problem.

Who should care​

The X201P suits write-heavy pipelines such as checkpoint dumps, data ingest and bulk loads. Queue depths there are high and throughput matters most. Plan airflow carefully for dense U.2 or E3.S bays.

Be more cautious with workloads dominated by QD1 or low-concurrency writes, such as transaction logs and commit-heavy databases. The same goes for mixed I/O at moderate queue depths. Those were the drive's weak areas in the review.

Peak figures from any single review are a starting point, not a guarantee. The review used one firmware version, one capacity and one bench. Validate on your own hosts, whether they run Windows Server, Linux or hypervisors.

Tom's Hardware gave the drive a 4 out of 5 rating.

Bottom line​

The X201P is a capable first big PCIe 5.0 enterprise showing from a company better known for consumer controllers. It's fast and spec-compliant, and it writes well at depth. It gives ground at low queue depths and ran warm. Match its strengths to your queue depths and read/write mix, and confirm the part number and cooling before you buy.

 

References

  1. Phison Pascari X201P 15.36TB SSD Review: Fast PCIe 5.0 write performance for AI and ingest servers Tom's Hardware 2026-11-17T13:13:48+00:00
  2. Phison Showcases aiDAPTIV+ Inference, New Client and Pascari Enterprise SSDs at CES 2026 - Phison Blog phisonblog.com