-
I
Windows 7 wd 500 blue
i have drive with two partition, C working fine, D is system reserve E put following problem chkdsk report is attatched after chkdsk E drive show no label and ask to format when try to open what to do Chkdsk was executed in read/write mode. Checking file system on E: The type of the...- itzAtlaf
- Thread
- bad clusters chkdsk data recovery disk management disk space drive issues file check file system formatting ntfs orphaned files partition read errors security descriptors storage system file checker troubleshooting volume label wd blue windows error
- Replies: 17
- Forum: Windows Hardware
-
Windows 7 Format HDD from Command Prompt, X: drive or Boot volume
So I am wiping my hard drive by booting with the Windows disk and going to command prompt. I successfully formatted drive C:, about 100 MB of system files and D:, about 500 GB or the bulk of my hard rive. These were the same hard drive, but separate partitions apparently. In Windows it just...- jonfd
- Thread
- boot volume command prompt data wiping disk formatting disk management executable file system formatting hard drive hdd partition root directory system files volume label windows installation write protection
- Replies: 1
- Forum: Windows Help and Support
-
A
Windows 7 Can not set system protection on a drive
I'm running Windows7 Ultimate 64-bit. I went in to the control panel/System Protection to turn on Protection on the drive that contain my documents so I could use the "Restore Previous versions". When I attempted to do so I got an error stating "Could not apply settings for the following reason...- AirForce2117
- Thread
- control panel documents drive error restore settings syntax error system protection volume label windows 7
- Replies: 2
- Forum: Windows Help and Support
-
Windows 7 System Restore Problems
Hello, I am running Windows 7 Home Premium 64 bit in Classic mode. My system specs are listed below my signature. Before installing a program today I went to create a system restore point. In System Properties > System Protection I see that in Protection Settings > Available Drives there are...- Dave McKeen
- Thread
- asus backup classic mode configuration disk space file syntax hard drive protection protection settings restore point ssd storage issues system image system properties system restore tech support user help volume label windows 7
- Replies: 9
- Forum: Windows Help and Support
-
W
Windows 7 Please help: file system corruption but run check disk takes me to system restore and restore right
When I start up my computer it shows NTFS volume label Acer C can't run due to error in recently installed software (I haven't installed any software in a long time, I have however gotten a new Targus High Speed SD/SDHC/MMC Card Reader/writer, which the software auto installed by windows) the...- wiviking
- Thread
- acer auto install backup card reader corruption disk check disk issues error file system flash drive hard drive ntfs software installation system restore troubleshooting usb volume label windows 7 windows issues windows recovery
- Replies: 1
- Forum: Windows Help and Support
-
G
Windows 7 Fixing System Restore Error 0x8007007b on Windows 7 RC 7100 x64
when i try to turn on system restore for my c drive i get 'could not apply the settings for the following reason the filename directory name or volume label syntax is incorrect 0x8007007b' any ideas? --windows 7 rc 7100 x64- geekmaster1
- Thread
- backup disk management error file names help settings system restore troubleshooting volume label windows 7
- Replies: 1
- Forum: Windows Help and Support
-
E
Windows 7 Change of Volume Label
How do change Volume Label? Message shows "Access denied"- EQ2000
- Thread
- access denied change label disk management file system troubleshooting user rights volume label windows 10 windows 11
- Replies: 5
- Forum: Windows Help and Support