I believe that I succeeded in soldering the capacitor, but that leaves one problem that I'm struggling with. The little wire that I broke off from the connector on the LCD itself. The connector is a small 3 pin connector, that only the two outer pins are used, one with a red wire and the other with white. It is the white wire that is broken. I pulled the broken piece out of the connector, and as far as I can tell, no solder was used. I think it is one in which the wire is supposed to only be pushed in and caught by an internal locking device. The problem is that I can't seem to even start the wire into the hole, even though I stripped a small length of the insulation. I even tried by using needle nose pliers, so that I could grip the wire up close, but it still bends before going in. Is there a trick to making this work?