OK so I'm trying to go a fresh install on my workstation (info below). I was able to boot to the DVD and the installation seemed to go fine (on the sata drive, for some reason the computer doesn't detect the scsi drive). But when windows tries to boot for the first time the computer restarts after the "setup is preparing your computer for the first time" screen. Then upon reboot the computer displays the "hey the computer obviously didnt shut down properly don't you wanna try safe mode ect." Tried safe mode and failed...(seemed to hang up at the agp440 driver) also tried last known good config and no success. The hard drive is fine, I have xp running on another partition, and data stored on a 3rd. Any ideas???
HP Workstation xw6000
Processor
2 Intel Xeon processors at 2.4, GHz with 512 KB L2 cache
Front Side Bus 533 MHz
Chipset Intel E7505
Memory Up to 8 GB of Registered ECC PC2100 DDR-266 memory (4 DIMMs in 2 pairs, dual-channel architecture)
Drive controllers
Integrated dual-channel Ultra320 SCSI controller and integrated Ultra ATA/100
Optional Ultra160 or dual-channel Ultra320 SCSI controllers
This device driver got stuck in an infinite loop, this usually indicates a problem with the driver itself or with the device driver programing hardware incorrectly