hello i got wns server to start

[ws1960]

how do i get LSI added as will not boot with it installed and i think i can fix raid from this window see pic. the alarm is what i need to turn off [Failed Drive alarm].

 

[WindowsForum AI]

That picture helps a lot.

What you’re actually in (important)​

Your screen is not the newer “MegaRAID” utility. It’s:

• LSI Software RAID Configuration Utility vA.60 (Jul 30, 2008)
• BIOS Version: M1068e… (LSI SAS1068E family)

And the bottom line shows it’s keyboard-driven:

“Use Cursor Keys … and press Enter …”

So if you were trying to “click Start” with a mouse/trackpad, it can look like it’s frozen. Use arrow keys + Enter (ideally with a wired USB keyboard).

---

A) Turn off / silence the “Failed Drive” alarm (beeping)​

On these LSI RAID BIOS utilities, the alarm control is usually under Objects.
Try this path:

• From that main menu, use Arrow Down to Objects → press Enter
• Look for Adapter (or sometimes SAS Topology / Controller) → Enter
• Look for something like:
• Alarm Control
• Silence Alarm
• Disable Alarm
• Mute
• Set it to Disabled/Silenced, then Save/Exit

If you tell me what options you see after Objects, I can give the exact keystrokes (the wording varies by firmware).

If you just want the beeping to stop right now​

Many Supermicro cases also have a chassis/buzzer that can be silenced temporarily, but since you’re seeing “Failed Drive alarm,” the clean way is in the RAID utility as above.

---

B) “How do I get LSI added as it will not boot with it installed?”​

If the system “won’t boot” with the LSI installed, it’s usually because it’s getting stuck in the RAID option-ROM stage due to one of these:

• A bad drive / bad cable / bad backplane causing the controller to hang while scanning
• Boot order trying to boot from the RAID controller first
• Less common: the controller itself is unstable

Fast isolation test (high value)​

Because your data is not critical, you can be more aggressive:

• Power off
• Leave the LSI card installed, but disconnect the SAS/SATA data cable(s) from the LSI to the drive cage/backplane
• Boot

If it now boots normally: one of the drives, the backplane, or the cable is likely causing the hang.
Then reconnect drives one cable / one set at a time to find which side triggers the issue.

---

C) Caution: don’t pick the wrong menu item​

From your main menu:

• Rebuild = usually safe (doesn’t wipe metadata)
• Check Consistency = generally safe (can take a long time)
• Initialize = often destructive (can wipe the array / data)
• Configure = can be destructive if you create a new config

So unless you’re intentionally wiping and starting over, avoid “Initialize”.

---

Two questions so I can give exact steps​

• When you go to Objects, what submenu items do you see? (Adapter / Physical Drive / Logical Drive / etc.)
• How many drives are in the RAID set, and does the utility show any drive as FAILED / MISSING / OFFLINE?
  If you can snap a second photo of the Objects screen (or list the items), I’ll tell you precisely where the Alarm Disable/Silence option is in your menu.