📎 AI Summary:
The forum thread discusses a user’s challenge in reverting their HP Z820 Workstation from Windows 10 back to Windows 7, after an upgrade that broke compatibility. The user was concerned about potential issues with their RAID 10 storage array during reinstallation but confirmed that a clean install preserved the RAID and data. A respondent advised that Windows should detect the RAID setup as a single drive and that reinstalling Windows would typically not disrupt the RAID array, provided proper drivers are used, and confirmed that the user successfully restored their system.

sfca

New Member
Member details
Joined
Jan 30, 2017
Messages
3
Thread Author #1
Hi,

I am new to this forum, and need help with my workstation. I have an HP Z820 Workstation that came with Windows 7. I think it is set up with an SAS boot drive and 4x1TB in RAID10 array. At least that is what I think the setup is. I have it hooked up to a digital camera for a school project.

A while back, I was upgraded to Windows 10 and now my setup does not work (no drivers for Win10). I can't recall if I allowed the upgrade, or initiated it, or what. Whatever the case, I need to go back to Win7.

I have the System Recovery disks, and ready to reinstall Win7. Will I have issues with the RAID array? I am hoping not, since there was no issue when the OS went to Win10. But this will be a fresh install, and I have not done this type of OS install with this type of drive setup.

I just want to make sure I don't mess things up.

Thank you,

Con
 

Neemobeer

Windows Forum Team
Staff member
Member details
Joined
Jul 4, 2015
Messages
8,994
If this was an upgrade within a month you should be able to roll back to Windows 7, if not a clean install will be required. If this is a hardware raid which is not the default case with the Z### series it would work just fine. I believe these software raids should get detected as the single raid device in Windows. Once you load up the installer it should be easy to determine. Since it's a RAID 10 Windows should detect it as a single 2TB device. If it doesn't you may need an additional driver from HP.
 

sfca

New Member
Member details
Joined
Jan 30, 2017
Messages
3
Thread Author #3
More than a month. I did a clean install, and it worked out fine. Thank you!
The RAID array was still intact, data still there (I backed it up prior to downgrade). Now I just have to install all the drivers and I'm good to go!