Evening all , When I burn a 8.5GB Dual layer dvd , it only gets about halfway then the picture sticks . I have had this happen before , quite a few years ago now . I think its something to do with not all the dvd being burned properly . I tried it today on Nero 2018 Platinum , its been years since I last tried . I thought maybe the problem had been sorted ,but its just the same .Last time I tried I watched the film till it stopped halfway , ( or near enough ) . This time I used the chapters to advance to almost halfway , then played the dvd a bit with the exact same result . The film stopping with the picture still on screen , i realise its not much to complain about , but if someone knows where i'm going wrong ( it's obvious i'm doing something wrong ) . Or knows any software you can get that burns dual layer dvds without the failures i would be very grateful , it would be nice to be able to watch a dual layer dvd that played to the end of the film . Thank you .