Rosewill RNX-N300 Not recognized

Discussion in 'Windows 7 Networking' started by Kyle Hayes, Apr 4, 2012.

  1. Kyle Hayes

    Kyle Hayes New Member

    Joined:
    Apr 4, 2012
    Messages:
    4
    Likes Received:
    0
    Okay, so I finally got a wireless card in today but my windows 7 is not reconizing it, even after installing the latest
    [FONT=inherit !important][FONT=inherit !important]drivers[/FONT][/FONT]
    . I have tried both PCI slots on my MB (ASRock 970 Extreme 3) and both lights on the card are lighting up in each one. I even went into the UEFI to make sure PCI slots were enabled. Any suggestions? Thanks!
     
  2. Saltgrass

    Saltgrass Excellent Member
    Microsoft Community Contributor

    Joined:
    Oct 16, 2009
    Messages:
    15,157
    Likes Received:
    393
    Use the Winkey and type ncpa.cpl to open the connections control panel. From what you say, I assume the adapter is not shown?

    After you installed the drivers, then installed the card, did you get the big R to configure the card?

    The driver you are using is rnx-n300_v1.4.1.exe?
     
  3. Kyle Hayes

    Kyle Hayes New Member

    Joined:
    Apr 4, 2012
    Messages:
    4
    Likes Received:
    0
    well my computer is finally recognizing the card but now I am getting no wireless connections whatsoever. I even created an ad-hoc network on my laptop that is literally two feet away and still not getting anything to connect to. I do believe it is DOA at this point. Sigh
     

Share This Page

Loading...