Windows 10 Windows 10 stuck on repair screen after new hardware installation

Babs767

New Member
Joined
Dec 6, 2019
Messages
6
I recently installed new hardware. After installing the new hardware I can't get pass the windows repair screen. I've tried restarting and even changing the boot drive by nothing is working
Old harware: i7 3700
As rock itx motherboard
16 GB DDR3 ram(not sure of speed)dual
channel
New Hardware: i7 9700k
Msi Meg Ace Z390
16 GB DDR4 2666 dual channel
 
Sort by date Sort by votes
nmsuk is absolutely right. It's a bit more than a hardware change. It's a new machine ! Even if you do sort it out it would take so long you'd end up wishing you'd done a clean install. Pain but true.
 
Upvote 0 Downvote
HI And stop others 3parti spypprograms / other sequipment wen the load that

ONLY INERNET./ Make sure the old board BIOS was not set to IDE mode and the new one is ACHI
 
Last edited:
Upvote 0 Downvote
HI And stop ool others 3parti spypprograms / other sequipment wen the load that
Connect your machine to your router or modem.
 
Upvote 0 Downvote
You must log in or register to reply here.