Windows 10 Windows 10 stuck on repair screen after new hardware installation

[Babs767]

I recently installed new hardware. After installing the new hardware I can't get pass the windows repair screen. I've tried restarting and even changing the boot drive by nothing is working
Old harware: i7 3700
As rock itx motherboard
16 GB DDR3 ram(not sure of speed)dual
channel
New Hardware: i7 9700k
Msi Meg Ace Z390
16 GB DDR4 2666 dual channel

 

[nmsuk]

You really need to do a clean install of windows.

 

[Babs767]

You really need to do a clean install of windows.

Thanks I'll try that

 

[Keith W]

nmsuk is absolutely right. It's a bit more than a hardware change. It's a new machine ! Even if you do sort it out it would take so long you'd end up wishing you'd done a clean install. Pain but true.

 

[helpifIcan]

Make sure the old board BIOS was not set to IDE mode and the new one is ACHI

 

[Babs767]

Make sure the old board BIOS was not set to IDE mode and the new one is ACHI

I don't have access to my old board since the reason I changed was because it broke

 

[Babs767]

You really need to do a clean install of windows.

I did a clean install of windows, I still end up with the same thing

 

[Rapaaja]

HI like
nmsuk
Ses You really need to do a clean install of windows. Download Windows 10

 

[Babs767]

HI like
nmsuk
Ses You really need to do a clean install of windows. Download Windows 10

I've already done one

 

[Rapaaja]

HI And stop others 3parti spypprograms / other sequipment wen the load that

ONLY INERNET./ Make sure the old board BIOS was not set to IDE mode and the new one is ACHI

 

[Babs767]

I

HI And stop others 3parti spypprograms / other sequipment wen the load that

ONLY INERNET./ Make sure the old board BIOS was not set to IDE mode and the new one is ACHI

I have no access to the old board

 

[helpifIcan]

The only other thing I can think of is to go into the BIOS and if set to IDE change to ACHI, if ACHI change to IDE.

 

[nmsuk]

Do not change it to IDE, that shouldn't be needed.

 

[Rapaaja]

HI And stop ool others 3parti spypprograms / other sequipment wen the load that
Connect your machine to your router or modem.

 

[samK]

You might need to go ahead and proceed with new installation of Windows 10.

 

[albert709]

The only other thing I can think of is to go into the BIOS and if set to IDE change to ACHI, if ACHI change to IDE.