i have drive with two partition, C working fine, D is system reserve
E put following problem
chkdsk report is attatched
after chkdsk E drive show no label and ask to format when try to open
what to do
Chkdsk was executed in read/write mode.
Checking file system on E:
The type of the...
bad clusters
chkdsk
data recovery
disk management
disk space
drive issues
file check
file system
formatting
ntfs
orphaned files
partition
read errors
security descriptors
storage
system file checker
troubleshooting
volumelabel
wd blue
windows error
So I am wiping my hard drive by booting with the Windows disk and going to command prompt. I successfully formatted drive C:, about 100 MB of system files and D:, about 500 GB or the bulk of my hard rive. These were the same hard drive, but separate partitions apparently. In Windows it just...
boot volume
command prompt
data wiping
disk formatting
disk management
executable
file system
formatting
hard drive
hdd
partition
root directory
system files
volumelabel
windows installation
write protection
I'm running Windows7 Ultimate 64-bit. I went in to the control panel/System Protection to turn on Protection on the drive that contain my documents so I could use the "Restore Previous versions". When I attempted to do so I got an error stating "Could not apply settings for the following reason...
Hello, I am running Windows 7 Home Premium 64 bit in Classic mode. My system specs are listed below my signature.
Before installing a program today I went to create a system restore point. In System Properties > System Protection I see that in Protection Settings > Available Drives there are...
asus
backup
classic mode
configuration
disk space
error message
file syntax
hard drive
protection
protection settings
restore point
ssd
storage issues
system image
system properties
system restore
tech support
user help
volumelabel
windows 7
When I start up my computer it shows
NTFS volume label Acer C
can't run due to error in recently installed software (I haven't installed any software in a long time, I have however gotten a new Targus High Speed SD/SDHC/MMC Card Reader/writer, which the software auto installed by windows) the...
acer
auto install
backup
card reader
corruption
disk check
disk issues
error
file system
flash drive
hard drive
ntfs
software installation
system restore
troubleshooting
usb
volumelabel
windows 7
windows issues
windows recovery
when i try to turn on system restore for my c drive i get 'could not apply the settings for the following reason the filename directory name or volume label syntax is incorrect 0x8007007b'
any ideas?
--windows 7 rc 7100 x64