Ricey
New Member
- Joined
- Feb 9, 2019
- Messages
- 4
- Thread Author
-
- #1
I have 7 on my laptop but I want to upgrade too 10. I have done this on this laptop before with 7,8 and 10. Alwats worked. I do my install with a USB
I hsvr no cd drive on my acer ultra-book so I have to use a USB.. Normally I would use rufus and put 10 on the usb, turn off my laptop, boot up and hit F12
then selech to boot from the USB. Now if I try to do it (CLICK ON BOOT TO USB) It just boots back to the windows 7 I have already installed. I have tried a few USB
drives but all give the same result.
Can anyone think of why this is going on?
Any help will be very much appreciated!!!!!
Regards.
I hsvr no cd drive on my acer ultra-book so I have to use a USB.. Normally I would use rufus and put 10 on the usb, turn off my laptop, boot up and hit F12
then selech to boot from the USB. Now if I try to do it (CLICK ON BOOT TO USB) It just boots back to the windows 7 I have already installed. I have tried a few USB
drives but all give the same result.
Can anyone think of why this is going on?
Any help will be very much appreciated!!!!!
Regards.
Solution
If it's booting back to Windows then the computer isn't recognizing the usb drive as valid. Most likely you have a mismatch in partition / boot scheme MBR versus UEFI
- Joined
- May 1, 2008
- Messages
- 5,554
how can I run an install from the iso?
ty
The Iso must be in a separate partition of minimum size to accomodate it , which you can create. Right Click it and "mount" it. Among the programs you will see the setup exe
Last edited:
Similar threads
- Solved
- Replies
- 6
- Views
- 1K
- Solved
- Replies
- 3
- Views
- 3K
- Solved
- Replies
- 1
- Views
- 2K
- Solved
- Replies
- 1
- Views
- 1K