Windows server 2016 with Silicon Sil3114 Raid5 system with MSI Main board won't boot

[Kentos]

Hi
I have installed Windows server 2016 essentials on a system using Silicon Sil3114 Raid5 with 3 4TB Drives the install went find as normal but the system will not boot. When the system is starting up I hit <F11> and the Raid5 system is there as an option to boot on, but when I select it, it just comes up asking to insert a boot disk. I tried re-installing windows again and this time it did see the previous install and even told me that it would copy the previous windows to windows old folder.
but the same thing happens the second time as well.

Any help would be greatly apricated

 

[ChatGPT]

It seems like there might be an issue with the boot configuration on your RAID array. Here are some steps to troubleshoot and potentially resolve the boot issue with your Windows Server 2016 Essentials installation on the Silicon Sil3114 RAID5 setup: 1. Ensure Proper Boot Configuration: - Check the BIOS settings to ensure that the RAID array is set as the primary boot device. Sometimes, the boot settings need to be adjusted to prioritize the RAID array. 2. Verify RAID Array Health: - Confirm that the RAID array is healthy and properly configured. Check the RAID controller's settings or configuration utility to ensure that the drives are recognized and the RAID array is functional. 3. Repair the Boot Configuration: - Boot from the Windows Server installation media and choose the repair option. Use the Command Prompt to run bootrec commands like:

 bootrec /fixmbr bootrec /fixboot bootrec /rebuildbcd

- These commands can help repair the Master Boot Record (MBR) and boot configuration data. 4. Check RAID Controller Settings: - Review the RAID controller settings to ensure that the boot drive and RAID configuration are correctly set up. Make sure the RAID controller is functioning as expected. 5. Drivers and Updates: - Ensure that you have the latest drivers for the Silicon Sil3114 RAID controller and any necessary updates for Windows Server 2016 Essentials. 6. Rebuild the RAID Array: - As a last resort, you might need to rebuild the RAID array. This involves backing up data, recreating the array, and restoring the data afterward. 7. Data Recovery: - If the boot issue persists, consider retrieving data from the drives using specialized data recovery software before rebuilding the RAID array. If the issue continues after these steps, it might be beneficial to contact the RAID controller's manufacturer or refer to their support documentation for guidance specific to the Silicon Sil3114 RAID controller. RAID setups can sometimes be complex, and professional assistance may be required to troubleshoot effectively.