Windows 7 Error after setup, boot faliure

gulranek

New Member
Joined
Nov 2, 2009
Hi everyone!

I just tried installing the Win7 Ultimate 64-bit edition on my ASUS U81A notebook. The setup went fine, and after entering the serial number and restarting the computer, upon entering the login phase, there was an error, I can't recall exactly what it was, but it was something in the line of "logon faliure for some reason", I couldn't even read it properly because the laptop restarted promptly. After that, I got the boot faliure and unfortunately had to reinstall Vista from the recovery partition.

Any ideas?

P.S. First I tried formatting the disk and then installing Win7, encountered the problem, installed Vista from the recovery partition, then tried installing Win7 from Vista, but again the same problem.
 
Hi everyone!

I just tried installing the Win7 Ultimate 64-bit edition on my ASUS U81A notebook. The setup went fine, and after entering the serial number and restarting the computer, upon entering the login phase, there was an error, I can't recall exactly what it was, but it was something in the line of "logon faliure for some reason", I couldn't even read it properly because the laptop restarted promptly. After that, I got the boot faliure and unfortunately had to reinstall Vista from the recovery partition.

Any ideas?

P.S. First I tried formatting the disk and then installing Win7, encountered the problem, installed Vista from the recovery partition, then tried installing Win7 from Vista, but again the same problem.
I assume you are using the Retail disk, if not you may have to re-burn your ISO at a lower speed. Also, you should run the compatibility wizard and uninstall anything in Vista that might cause problems. Finally, run MSCONFIG and turn off all non-microsoft services and uncheck everything loading at boot. One or more of these possibilities might get you installed. Otherwise, do like most and do a clean install and dual-boot to Vista while moving stuff over at your leisure.
 
Yeah, I tried a clean install (as I wrote in my first post), the same thing happened. I checked my dvd after I burnt it, the data was verified correctly.
 
You might check and see if the Recovery partition is marked Active.


Hi everyone!

I just tried installing the Win7 Ultimate 64-bit edition on my ASUS U81A notebook. The setup went fine, and after entering the serial number and restarting the computer, upon entering the login phase, there was an error, I can't recall exactly what it was, but it was something in the line of "logon faliure for some reason", I couldn't even read it properly because the laptop restarted promptly. After that, I got the boot faliure and unfortunately had to reinstall Vista from the recovery partition.

Any ideas?

P.S. First I tried formatting the disk and then installing Win7, encountered the problem, installed Vista from the recovery partition, then tried installing Win7 from Vista, but again the same problem.
 
Back
Top Bottom