Code:
*******************************************************************************
* *
* Bugcheck Analysis *
* *
*******************************************************************************
Use !analyze -v to get detailed debugging information.
BugCheck 7A, {4, 0, ffffb106645923c0, 7eb4d30}
*** WARNING: Unable to verify timestamp for win32k.sys
*** ERROR: Module load completed but symbols could not be loaded for win32k.sys
Probably caused by : memory_corruption
Followup: memory_corruption
Hi,
this bugcheck is created when kernel data cannot be read into memory causes can include HDD issues, memory issues and viral infection.
Looks like your running MSE? If so please remove and just use the onboard Defender.
Can you please go through your driver list and update using only the drivers from your systems support page:
http://support.toshiba.com/support/modelHome?freeText=3520517 If the bsod continues then you'll need to test your RAM. Windows does have a memory testing app but it can miss errors and the best app for the job is Memtest86.
If you open the link below you'll see you can run Memtest86 in two ways. You can either burn it to disk or install it onto a USB drive it's entirely up to you. You'll then need to enter the bios to change the boot order so you can boot from either the Disk or USB stick you have Memtest86 on.
You must test for at least 12 hours unless it becomes obvious there is a problem straight away.
Memtest86+ - Advanced Memory Diagnostic Tool Run a chkdsk:
The How-To Geek Guide to Using Check Disk in Windows 7, 8, or 10 Please post any results and/or dump files.