Hello everyone,
I am about to install a Windows Embedded solution in a hardware that has an embedded switch.
This hardware will essentially have two different networks, LAN (embedded switch) and WAN (independent ethernet port). (Please note, in this case WAN is not the internet, it is another separated network with different subnet, where the only link is this Windows machine)
I need to know if it is possible to activate the routing functions in Windows Embedded 7 much the same way you can do it in Windows 7 Ultimate:
Reference -> wikihow com/Enable-IP-Routing
The main purpose is to be able to activate NAT function where I can port forward any requests from the WAN network to specific IP and ports in the LAN network.
I uploaded a diagram explaining what I need, which I hope is clear, I'm not very good at drawing these kind of diagrams... and I use MSPaint for the job most of the time.
Hope someone can help me in this.
I am about to install a Windows Embedded solution in a hardware that has an embedded switch.
This hardware will essentially have two different networks, LAN (embedded switch) and WAN (independent ethernet port). (Please note, in this case WAN is not the internet, it is another separated network with different subnet, where the only link is this Windows machine)
I need to know if it is possible to activate the routing functions in Windows Embedded 7 much the same way you can do it in Windows 7 Ultimate:
Reference -> wikihow com/Enable-IP-Routing
The main purpose is to be able to activate NAT function where I can port forward any requests from the WAN network to specific IP and ports in the LAN network.
I uploaded a diagram explaining what I need, which I hope is clear, I'm not very good at drawing these kind of diagrams... and I use MSPaint for the job most of the time.
Hope someone can help me in this.