Code:
*******************************************************************************
* *
* Bugcheck Analysis *
* *
*******************************************************************************
Use !analyze -v to get detailed debugging information.
BugCheck 7F, {8, 80050033, 406f8, fffff800032bd54f}
*** WARNING: Unable to verify timestamp for win32k.sys
*** ERROR: Module load completed but symbols could not be loaded for win32k.sys
Probably caused by : ntkrnlmp.exe ( nt!KiDoubleFaultAbort+b2 )
Followup: MachineOwner
Hi,
this particular 7F is down to either drivers taking up too much space on the kernel stack or a hardware issue.
If you have updated anything recently either drivers or hardware then see if removing stops the issue.
Looking over your drivers I noticed you have this installed:
NTIOLib_X64.sys Thu Oct 25 11:27:58 2012: MSI Afterburner driver (known
BSOD issues with Windows) Also found to be a part of MSI Live Update 5, MSI Super Charger & MSI Smart Utilities.
Try either removing this application or at least updating it to a more recent version to see if the bsod stops. If your overclocking please stop until bsod is stopped
Try running these scans to see if the system has any corruption:
File scans
Right click on the Start menu icon and from the revealed list choose 'admin command prompt'. Type:
sfc /scannow
press enter and await results
In the same command prompt and after the above scan has finished type:
dism /online /cleanup-image /restorehealth
Press enter and await results (longer this time).
If the first scan found files it could not repair but the second scan is successful, run the first scan again using the same command prompt box and this time it should repair the files found.
As Neem's points out above if the bsod continues then it would be prudent to check your hardware.
Check your CPU by using
Intels diagnostictool for checking processors.
If the bsod continues then you'll need to test your RAM. Windows does have a memory testing app but it can miss errors and the best app for the job is Memtest86.
If you open the link below you'll see you can run Memtest86 in two ways. You can either burn it to disk or install it onto a USB drive it's entirely up to you. You'll then need to enter the bios to change the boot order so you can boot from either the Disk or USB stick you have Memtest86 on.
You must test for at least 12 hours unless it becomes obvious there is a problem straight away.
Memtest86+ - Advanced Memory Diagnostic Tool