To be honest I'm unsure but at a guess I doubt it. Didn't you read my last post?Still crashing, and i can no longer revert back to windows 7.
Would dell datasafe local backup program revert me back to original factory settings of windows 7?
Run Seatools and check the drive:I've had a lot more bsod's this past week. One time windows wouldn't start, but instead displayed a screen which basically said "you need a new hard drive.."
It often starts up displaying:
Realtek PCIe FE Family Controller Series v1.24 (10/07/10)
PXE-E61: Media Test Failure, check cable
PXE-M0F: Exiting PXE ROM.
Reboot and Select proper Boot device
or Insert Boot Media in selected Boot device and press a key
Hmm... What are you going to use for drivers? As I said earlier you do not have any driver support for windows 10. You could try and risk it but may end up with Windows 10 installed but no sound or network.Should i reinstall windows?
As long as the partition is still ok that holds the data then it might work. It may not activate however as you have had windows 10 installed longer than 31 days.It claims it cna restore my compputer to factory settings. Woudl it bring me back to windows 7?
*******************************************************************************
* *
* Bugcheck Analysis *
* *
*******************************************************************************
Use !analyze -v to get detailed debugging information.
BugCheck F4, {3, fffffa8007a3fb10, fffffa8007a3fdf0, fffff80002d97750}
----- ETW minidump data unavailable-----
Probably caused by : csrss.exe
Followup: MachineOwner
EXCEPTION_CODE: (NTSTATUS) 0xc0000005 - The instruction at 0x%p referenced memory at 0x%p. The memory could not be %s.
*******************************************************************************
* *
* Bugcheck Analysis *
* *
*******************************************************************************
Use !analyze -v to get detailed debugging information.
BugCheck A, {fffff980000000e2, 2, 0, fffff80002d68944}
*** WARNING: Unable to verify timestamp for cewd64f.sys
*** ERROR: Module load completed but symbols could not be loaded for cewd64f.sys
Probably caused by : cewd64f.sys ( cewd64f+3e36 )
Followup: MachineOwner