Windows 7 bridge between network adpator in win 7

chuikingman

Active Member
Hi,
I have two network adpatro in win 7
one is lan card network adpator that use ip 10.1.4.100/16 Gw 10.1.1.249
one is VPN network adpator .If it enable , the IP will ber 192.168.2.X /24 .
I want to make bridge and so , the computer from 10.1.4.XXX /16 can use my computer to reach the 19.1.68.2.x .
In this case , my PC work as a router .
So , how can I make this ?? please advice in detail .
I try to make bridge with above two adaptor . But after enable the bridge ,
I still cannot ping ,telnet 192.168.2.XXX from 10.1.4.xxx PC even after
setup the route table .
 
Have tried software bridging - networking and sharing, select two adpators you want to bridge, right click and select bridging.
 
I only tried bridging a little with Virtualbox. One problem I encountered was the firewall settings. I was using Zone Alarm then and you had to create rules there to make it work.
Joe
 
I only tried bridging a little with Virtualbox. One problem I encountered was the firewall settings. I was using Zone Alarm then and you had to create rules there to make it work.
Joe
Please advice how you brigde the virtual adpator and real lan card net adpator detailed ....
 
Back
Top